Plastic test and analysis instrument

In order to test the proportion of plastic particles generally measured plastic particles due to the proportion of material is a material of all need to detect the ratio of the price with the proportion of the different proportion of the higher the price cheap for two times we must check the weight or do not know the proportion of high and low cost of our products are affected two times of regeneration material

Some of the quality of recycled materials is relatively good impurities compared to make out the particles are very rich particles are not hollow there is no small holes such recycled materials can be measured

Some of the quality of recycled materials are poor to do out of the particles are hollow holes such particles must be prepared to be measured or to take other methods of measurement

The following describes the specific gravity of the plastic, plastic testing and analysis of the detailed parameters of the analyzer;

A: the high precision of the United States host brand group long DX-120X /QUNLONG

Weighing accuracy: 0.001~120g density accuracy: 0.0001g/cm3

Solid measurement with water temperature compensation, can use other solution instead of water solution.

B: precision of the United States, the host of the United States Taiwan brand DX-300 /QUNLONG

Dual purpose and practical weighing accuracy: 0.01~300g density accuracy: 0.001g/cm3

C: ordinary type domestic group long MH-300A /QUNLONG

Weighing accuracy: 0.01~300g density accuracy: 0.001g/cm3

D private custom series

Solid measurement with water temperature compensation, can use other solutions instead of water solution.

Solid measurement with water temperature compensation, can use other solutions instead of water solution,.

More than six kinds of models in full accordance with the standard method of ASTM D792, GB/T 1033, EQV/ ISO/DIS 1183 and JIS K7112 as a whole, and the water displacement method based on the theory of Archimedes principle design. All can easily allow you to quickly take the amount of density.

Principle: the Archimedes principle of buoyancy method, accurate and direct measuring values.

Measurement time is not required to make a sheet

Here to say what kind of plastic particles can not be measured hollow products can not be measured

Measure note;

First; the product itself, please pay attention to observe some of the plastic particles have a needle like hole this kind of plastic particles to use alcohol measurement is more accurate. Water measurement error is relatively large, because the water is difficult to flow into the hole. If the measurement error is relatively large, it is recommended to measure the pressure of the sheet.

Second; plastic particles flash more, this plastic particle measurement must pay attention to the bubble, must be cleaned with alcohol, alcohol is more pure higher measuring accuracy.

Third; measurement of particles, the last step will be equipped with plastic particles tennis on the water, when there are tennis bubble when we want to use the burette to suck air bubbles (enough to buy Plastic particle density meter to our sales staff, can not take the request) in the sink inside the tweezers shakes, it is the error will affect the error.

The above is a plastic gravity meter, plastic detection and analysis of the introduction of a simple, if you are interested in understanding